0151 207 1400
£0.00
Free Delivery Over £100
Over 30 Years Experience
Excellent Customer Service
Dewalt & Makita Service Centre Free Delivery Over £100 Over 30 Years Experience Excellent Customer Service Dewalt & Makita Service Centre
Titebond 5178 Cold Press Veneer Glue 55 Gallon Drum
Stock Ref:
TITE-5178
Contact For More Info
-
Features & SpecificationTitebond Cold Press Veneer Glue 55 Gallon Drum -5178
Titebond Cold Press for Veneer is a high-quality, economical alternative to contact cement for large-scale bonding of veneers to flat surfaces. It is specifically formulated for cold press laminating of wood to solid woods, particleboard, MDF, plywood and other porous materials. Titebond Cold Press offers a modWood Glueerate speed of set, a translucent glue line and contains none of the harmful or corrosive fumes typical of most contact cements. It also prevents bleed-through on open-grained and unbacked wood veneers.
Features & Benefits
Economical alternative to contact cemenr
Moderate speed of set
Safe, non-flammable
Formulated to minimise "bleed-through"
No harmful vapours
Physical Properties
Type : Modified PVA emulsion
Calculated Voc : 2.0 g/L
State : Liquid
Weight Per Gallon : 9.2 lbs.
Color : Tan
Dried Film : Dark Brown
Flashpoint : > 200°F
Solids : 0.42
Freeze/Thaw Stability : Stable
Viscosity : 4,500 cps
Ph : 4.9
Chalk Temperature : To assure a good bond, 50°F is the lowest recommended temperature of the glue, air and materials during application.
Storage Life : 12 months in tightly closed containers at 70°F
Application Guidelines
Application Temperature : Above 50°F
Open Assembly Time : 15 minutes (70°F./50% RH)
Total Assembly Time : 15-20 minutes (70°F./50%RH)
Minimum Required Spread : Approximately 6 mils or 250 square feet per gallon
Required Pressure Application : 100-250 psi, depending on substrates
Method Of Application : For most consistent coverage a mechanical spreader is recommended.
Cleanup : Damp cloth while glue is wet. Scrape off and sand dried excess.
Limitations
Titebond Cold Press for Veneer is specifically designed for veneering and is not suited for other types of assembly applications. Not recommended for exterior use or where moisture is likely. Do not use when temperature, glue or materials are below 50°F. Freezing may not affect the function of the product but may cause it to thicken. Agitation should restore product to original form. Read MSDS before use. NOTE STIR PRODUCT BEFORE USE TO ENSURE UNIFORMITY. KEEP FROM FREEZING.
